Cardinal Gates Auto-Lock Pet Gate - Chewy, $77.99.To see how I made my labels, check out the full labeling tutorial HERE. Your final step is to add the vinyl labels to the covered closet dividers. ( NOTE: This is why you cut two from vinyl, one facing the opposite direction). Finally, pull the transfer tape away to reveal your perfectly-covered closet hanger!įlip the chipboard over and repeat with the other vinyl cut. ![]() Use your scraper vigorously on the vinyl+transfer paper combo to adhere the vinyl to the chipboard. If you got your placement right on the lower half, the upper half should lay right down and line up perfectly with the chipboard shape underneath. When you are satisfied with the placement of the first half of the vinyl covering, remove the paper backing from the rest of the door hanger decal. How the vinyl is placed here will determine how it lines up along the rest of the door hanger, so don’t hesitate to peel it up and try again to get it perfect. ![]() Take your time to line it up perfectly along the bottom edge and 2 corners. Use a scissors to trim away the exposed paper backing (shown below).Ĭarefully place the exposed half of the vinyl door hanger onto the corresponding side of the chipboard. Next, peel up only the bottom half of the vinyl shape off the paper backing. Lay a cut of Transfer Tape over the entire vinyl door hanger shape. Getting the vinyl shape to line up perfectly with the chipboard shape can be tricky, so here’s the best way to do it! To make these look prettier, I covered the chipboard in smooth vinyl. I love chipboard for its sturdiness, but I don’t love its rough, brown color/texture. Applying the Vinyl to the Hanging Closet Dividers Switch to the Fine Point Blade on your Cricut Maker to cut out the covers and labels from vinyl. ![]() If you’ve never cut out chipboard, refer to THESE comprehensive instructions.Īlthough these will take some time to fully cut through (plan for about 30 minutes per sheet), they should pop off your mat with perfectly clean edges. Start by cutting out the hanging dividers from chipboard using the Knife Blade. When you have the dividers sized and designed exactly as you want them, it’s time to cut everything out with your Cricut Maker!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |